Never come across any previous issues with connectivity on Serial before, except from incorrect/bad cable or USB adapters and PC settings. TERMON was a pure guess.so I would of been surprised if that was the problem.but one to keep in your memory locker. 1 on door should be enabled and used normally for KCWin32. 1 on 1GA/HA is usually disabled or for allocation of Floppy drive connection.
There are 2, 1 on door and 1 on 1GA/1HA board. Baud Rate: 9600, Data Bits: 8, Parity: None, Stop Bits: None, Flow Control: None.Īlso, which connection interface do you use on C40? Device Manager default COM port settings should be used: not same between Device Manager and KCWin32 Options - They need to be same no. Have you checked COM Port Settings in Device Manager (Windows)? If not, do you know port on Laptop is ok or damaged? These can be very different, I find cheap Chinese ones most reliable or Targus type. The version in software section is ok to use. So, your cable appears correct - No need for DTR/DSR/CTS/RTS/DCD connections as no handshake required.
All Kawasaki Controllers use Pins 2, 3 and 5 only.(cross over 2 and 3 one end as you say).
0 kommentar(er)
